Difference between the limited edition versions and the standard APK 165

• 2 ohms Component Speakers
• AP 1P Component Tweeters

AP 1P TWEETER COMPONENT

The exclusive AIF technology (Any Install Faceplate) of the AP 1P Tweeter component provides the installer with 3 different faceplates for total application versatility and a significant reduction in installation time. The double Neodymium tablet used in the motor provides an excellent extension in high frequency and together with the 1” CCAW voice coil ensures an outstanding dynamic response.

AP 6.5 Ω2

AP 6.5 Ω2 woofer has been developed with 2Ω nominal impedance with the purpose of exploiting all the power made available by the AP8.9 bit amplifier capable of 65W into a 2Ω load. To maximize the woofer efficiency achieving 95 dB, a 25 mm diameter 10 mm winding height coil, so a more lightweight coil, has been employed, at the same time also providing a linear excursion 2.8 mm higher than the one of AP 6.5 (4Ω), therefore ensuring high SPL values with minimum distortion even at high listening levels. To extend the woofer’s frequency range down to low frequencies up to 50 Hz a 75 Hz resonance frequency has been chosen, achieving excellent low frequency output even without the use of a subwoofer.

• Comp    Tweeter
• Size    29 mm (1.14″)
• Frequency Response    1,2 ÷ 25 kHz
• Crossover name
• APCX P 2T
• Crossover Type
• High Pass, 4kHz, 12 dB/oct.
• Crossover adjustment
• Tweeter Level: 0 / +3 dB
• Sensitivity    92 dB/Spl
• Magnet    Neodymium
• Tweeter Voice Coil Ø
• 25 mm (1″)
• Dome    Tetolon fibre
• Comp    Woofer
• Size    165 mm (6,5″)
• Power Handling    100 W Continuous Power
• Impedance    2 Ω
• Frequency Response    50 ÷ 5k Hz
• Sensitivity    95 dB/Spl
• Magnet    High density flux ferrite
• Dome    Water-repellent treated paper cone

• AP 6.5 C2 Woofers
• AP 1 C2 Tweeters
• APCX WF C2 Crossovers
• APCX TW C2 Crossovers
• Screws
• Fixings
• Angled Mounts
• Flush Mounts
• OEM Mounts