Product Information

Audiofrog designed their GS10 tweeter to deliver the high-frequency details in a well-powered, custom component system. The expansive 1" fabric dome delivers highs with a natural, silky, smooth quality, eliminating the distortion and ringing created by some metal and plastic domes. Audiofrog also uses a copper pole piece cap to extend the frequency response and improve the accuracy of this tweeter.

Creative installation

Audiofrog was founded by experienced installers, who know all the pitfalls and shortcuts of tweeter installation. Without a mounting bracket, the GS10 will fit a standard sawhole cut why hasn't anyone ever done that before? With this tweeter's unique metal mounting bracket, you'll find custom fabrication of pillar and sail panel pods much easier. The bracket's versatile straps provide for numerous installation scenarios as well. Audiofrog's unique spring and nut design for flush-mounting allows you to dial in the speaker's depth for the snuggest fit possible.

Any way you install it, this versatile tweeter gives you the potential to gain the widest possible soundstage for total musical immersion.

• 1" fabric dome tweeters (pair)
• universal mounting solutions
• recommended minimum high-pass filter frequency and slope for active systems: 12dB/octave, 3.5kH
• use with GS40 and GS410C or GS60 and GS610C or in systems with active crossovers
• power handling: 15-75 watts RMS (200 watts peak power)
• frequency response: 1,800-20,000 Hz
• sensitivity: 92 dB
• top-mount depth: 13/16"

Specification

• Design    1-way
• Tweeter Design    1" Dome
• Impedance (Ohms)    4
• Tweeter Composition    Fabric
• Sensitivity (1W at 1 meter)    N/A
• Sensitivity at 2.83 volts    92
• Frequency Response    1800 - 20k Hz
• Minimum RMS Wattage    15
• Maximum RMS Wattage    70
• Peak Power Handling (Watts)    200
• Top-mount Depth (Inches)    0 13/16
• Bottom-mount Depth (Inches)    1 3/8
• Cutout Diameter or Length (inches)    1 3/4
• Mounting Height (Inches)    0.448

What's Included

• 2 Tweeters
• 2 Flush-mount trim rings
• 2 Tensioning springs
• 2 Back plates
• 2 Strap mount brackets
• 2 Rear support brackets
• Eight M2x2.5mm Machine screws (1.5mm Allen head)
• Two M4 Stud bolts (2mm Allen head)
• 2 Star lock washers
• Six M4 Nuts
• Eight 5/8" Self-tapping screws (2.5mm Allen head)
• 2.5mm Allen head bit
• 2mm Allen key
• 1.5mm Allen key
• Instruction manual